Clear Cmos

As we know, CMOS is the memory where the data store hardware or computer components mounted in it, if the CMOS does not work with the normal operation of the computer will crash.

Things that make the CMOS does not work with normal antaralain caused:

    Possible CMOS Batre has been weak, so it can no longer mensupord power in CMOS when the computer dies.
    The habit of using equipment such as a USB Flash Drive, External Hard Drive directly in the pull without the Safely Remove Hardware, software installed and resulted in the CMOS data is stored and when the computer is turned on again Hardware CMOS data is not found.
    The possibility of an attack due to virus attack regystry windwos associated with CMOS so between CMOS and windows is not synkron.
    As a result of too frequent system failure without shutdown, resulting in the system does not save the CMOS settings, and are ready to save the CMOS settings for dimatiin sudden components.

If CMOS is disrupted computer usage is not stable, although all components of the computer is not damaged.

To overcome this you need to make improvements all the CMOS by removing the CMOS memory tersetting.

How:

1. Make sure your computer is not connected to the electricity grid.

2. Open CPU

Clr Cimos3. After the CPU cover in open view on your motherboard socket with writing CLR CMOS Jumper (As shown in the picture above, usually setting the jumper near the CMOS batry


4. Pin 1 and pin 2 when the jumper means the Normal position. unplug the jumper and move it to menjumper between pin 2 and pin 3.

5. Once you jumper pin 2 and pin 3, turn on the computer, and leave for half a minute, kemuidian turn off again.

6. After the computer turns off, return again to positions Setting Jumper position jumper pins 1 and 2.

7. Turn on the computer, the computer will ask you for setting up the Bios, press F1 or Del (depends on the order of a kind Mother Boardnya)

8. Select the Default setting Bios to Optimise the system Bios. then press F10 to save and exit BIOS into memory.

9. The computer will restart and work normally kembal.

10. When the computer has worked normally, shutdown the computer, and close the computer cover.